8 SNGLE PHASE H 8kW User Manual 2. PRODUCT INTRODUCTION This multifunctional inverter combines the functions of an inverter, solar charger and battery charger to offer uninterruptible power support with a portable size.
A master single phase inverter is capable to operate with other 15 slaves inverters. Thus, to parallel 16 in- verters in a single phase utility, one will operate as the master, and the other 15 will operate as slaves.
For the 8KW model, the recommended AC breaker for backup load is 63A. There are three terminal blocks with “Grid” “Load”and “GEN” markings. Please do not misconnect the input and output connectors. GEN/AUXGenerator connection. GRID This works like a conventional grid-tied inverter.
PV modules' Open circuit Voltage (Voc) does not exceed the max. PV array open circuit voltage of the inverter. 2. PV modules' Open circuit Voltage (Voc) should be higher than min. start voltage. 3. The PV modules connected to this inverter shall be Class A rating certified according to lEC 61730.
1 The maximum input voltage is the upper limit of the DC voltage. Any higher input DC voltage would probably damage the inverter 2 The AC frequency range may vary from different country codes.
View Details
And can support multiple inverters in parallel to form a single-phase or three-phase system with a maximum power of 48kW. With UPS switching and provides an independent generator
View Details
The certificate verifies that the inverter complies with the relevant Australian/International Safety Standard. Until recently, the CEC has required compliance with AS4777.2 (Grid Connect Inverter
View Details
The protection level is increased to IP66 and integrated rich safety functions, make PV plants extremely safe and reliable, actively avoid risks, rest assured to enjoy green electricity.
View Details
Grounding instructions - this inverter should be connected to a permanent grounded wiring system. Be sure to comply with local requirements and regulations to install this inverter. Never cause AC output
View Details
For instance, for an 8kW inverter, you would use the G99 A1-1 form, and for a 5kW inverter, you would use the G99 A1-2 form with a G100 Declaration if required.
View Details
UPS level redundant protection against backup load breakdown; Three-level firmware and two-level hardware battery protection; Multiple temperature monitoring, delicate thermal management.
View Details
And can support multiple inverters in parallel to form a single-phase or three-phase system with a maximum power of 48kW. With UPS switching and provides an independent generator interface to
View Details
Grid Regulation VDE4105, IEC61727/62116, VDE0126, AS4777.2, CEI 0 21, EN50549-1, G98, G99, C10-11, UNE217002, NBR16149/NBR16150 Safety EMC / Standard IEC/EN 61000-6-1/2/3/4, IEC/EN
View Details
Safety EMC / Standard IEC/EN 61000-6-1/2/3/4, IEC/EN 62109-1, IEC/EN 62109-2 V-TAC | VTACEXPORTS PAGE 1
View Details
The protection level is increased to IP66 and integrated rich safety functions,
View Details
Subject to change without notice. Version 1.1. Max. PV input voltage. Max. PV input current. Max. PV short-circuit current. Max. AC output current. 2019 Sungrow Power Supply Co., Ltd. All rights
View DetailsPDF version includes complete article with source references. Suitable for printing and offline reading.
